Installation Steps:

1. There are three mounting holes on the back of the stand, you can mark the wall according to the holes.
2. You can also measure the distance of the holes first. Measure the exact distance between the centers of the holes with a steel ruler (not included) and record it.
3. Mark the wall. Drill the holes with a No.6 drill bit (not included) to a depth of 0.11'' deeper than the expansion sleeve. Be careful to keep it perpendicular to the wall.
4. Tap the expansion sleeve into the hole with a hammer (not included). The expansion sleeve can be leveled with the wall surface.
5. Lock the screws with an electric drill in the punched expansion sleeve. The depth does not have to be too long, leave 0.19'' to avoid shaking.
6. Put the back of the product into the holes and press down to tighten the holes. If you're afraid of it wobbling, it can be reinforced with glass adhesive (not included) on the back of the product.

Notes

1.Please note that this product does not include other items such as nail polish.
2.Please stably install this product to avoid the risk of dropping it.
3.Please allow the slight color difference caused by the shooting light and 1-3cm error due to manual measurement, and make sure you do not mind before you order.