













Pneumatic Dispensing Controller Glue Dispenser Solder Fluid Controller 982
- Brand: CNCEST
- Product Code: JZON592OEUYJ8
- Availability: In Stock

Specifications
Color | Negro | Model | 982 |
Material | Metal | Spitting mode | Manual / Semi-automatic |
Minimum drip volume | 0,01 ml | Spitting time interval | 0,1-9,9 s |
Automatic sync (can be configured) | 0,01-30 s | Replay Accuracy | ±0,5% |
Internal voltage | 12-24CC | Inlet air pressure | 2.5-7 bar (35-100 psi) |
Outlet air pressure | 0.1-5.5 bar (1-78 psi) | Power supply | 220 VCA, 50 Hz |
Energy consumption | 20W | Plug specification | European standard 220V |
Product size | 23*15*6cm/9.05*5.9*2.36inch | Package size | 20*26*14cm/10*9*12.5inch |
Gross weight | 2.1kg/4.63lbs |
Product Tips


Grades
1.The high inlet pressure should not exceed 7 bar (100 psi) and the maximum working pressure of the glue dropper should not exceed 5.5 bar (78 psi). If the working air pressure is higher than 4 bar, please change to aluminum connectors. 2.If available, store all materials at a constant temperature (5°C) as directed to ensure that the concentration does not change significantly during use. 3. When the concentration of the material is too large (flow difficulties), it cannot be dripped, if you want to use it, according to the manufacturer's instructions, please dilute the use; Before working, the material must be thoroughly stirred evenly to ensure that the drip size is consistent. 4. In automatic state, the general setting of the air pressure in the machine at 1-2.7 bar (15-40 psi) is more appropriate. When working in the automatic state, the force of the vacuum tube pumping air must be adjusted to the appropriate position. Too much pumping will flush the piston and destroy normal operation. 5. Work in automatic state, according to the actual situation, timely removal of the material left in the needle nozzle, these gradually curing materials will block the mouth discharge and pumping back; after work, the barrel must be cleaned in time; Otherwise, it will be very difficult to disassemble. 6. Please allow slight color difference caused by shooting light and 1-3cm error due to manual measurement and make sure you do not mind before ordering.
Loading...
Loading...
Loading...
Loading...