







Electric commercial snow machine, ice crusher, crushed ice machine
- Brand: CNCEST
- Product Code: OT-ML-285
- Availability: In Stock

Specifications
Color | Blue | Style | Modern |
Process | Polishing | Plug | EU Standard |
Number of Blades | 1 | Material | Plastic, Aluminum Alloy, Stainless Steel |
Operating Mode | Electrical Powered | Adjustable Ice Thickness | Yes |
Rotating Speed | 2200 rpm | Power Cord Length | 1.5m/4.92ft |
Power | 380W | Voltage | 220V |
Frequency | 50Hz | Crushed Ice Capacity | 65kg/H/143.3lbs/H |
Product Size | 40*18*31cm/15.75*7.08*12.2in | Package Size | 42*20.5*32cm/16.54*8.07*12.6in |
Product Tips


Notes
1.Please check that the power supply voltage matches the voltage of this machine, and the power supply should be connected to a reliable ground.
2.Please make sure that the outlet of the ice particles can not be blocked when you use it, otherwise, it will be stuck and burn the motor, if the above phenomenon occurs, please find out the reason immediately, cut off the power supply, and lift the handle.
3.Please put the appropriate size of ice into the elbow, the ice should not be too broken, the size of a single piece of ice to just fit into the elbow and hanging out of the elbow less than 0.79 inches is good. The amount of ice loaded should not exceed the plane of the crushed ice cylinder.
4.Please keep your hands away from the blades. Please do not push the ice down with your fingers. Children should use this product with the accompaniment of an adult.
5.After using the ice crusher, you should turn off the switch, pull out the power plug, make a dry towel to dry the water particles on the body, and place it in a dry place.
6.Please allow the slight color difference caused by the shooting light and 1-3cm error due to manual measurement, and make sure you do not mind before you order.

How to Adjust the Thickness of the Ice
Step 1: Please turn the cutter plate.
Step 2: Stop turning when you see a hex screw from inside the ice outlet and unscrew it with a hex screwdriver(not included).
Step 3: Adjust the two screws on top of the cutter plate to adjust the thickness of the ice.
Loading...
Loading...
Loading...
Loading...