Notes

1.Please note that the wall suitable for installation must be a solid load-bearing wall that can withstand the weight after being filled with water. If it is not a load-bearing wall, corresponding protective measures must be taken, including installing brackets and reinforcing with through wall screws(not included).
2.Please note that there should be reliable drainage facilities such as floor drains near the installation location of the water heater.
3.Please note that it cannot be installed on the ground, does not support hidden/semi-hidden installation, and is prohibited from installing suspended inlet mixing valves.
4.Please read the manual and product label completely before use, and pay particular attention to the safety instructions included. Please beware of potential safety hazards when using electricity. Improper installation may lead to significant safety hazards so it is important to ensure that it is installed by professionals and not install it on your own.
5.Please note that when used for the first time, you must fill the water first and then power it later.
6.Please do not self-load, unload, or replace any part of the water heater. The water inlet must be positioned upright, vertically upward, not sideways or flat. The water heated through it is not recommended for direct consumption.
7.Please note that it is strictly forbidden to plug the outlet of a one-way relief value, and the additional pressure is greater when the inner tank is heated by thermal expansion. At 0.7mpa, the one-way safety valve will automatically drip and release pressure to ensure safety.
8.The connection pipe of the water supply pipe and water heater must be all metal tubes, not plastic.
9.Please allow the slight color difference caused by the shooting light and 1-3cm error due to manual measurement, and make sure you do not mind before ordering.